Carrying a handbag around at festivals is pretty impractical and it can be annoying when you want to dance etc, using a rucksack is one way of keeping your hands free, but for quick access to your drink, this pretty bottle holder should come in useful!
These are really quick to make and can easily be customised to personal taste. I have included a step by step guide below.
You will need:
1. Roughly 12x 12 inches of plain coloured fabric, 12 x 4 inches of patterned fabric. The size can depend on how big a bottle you are intending to carry around.
2. Three different colours of bias binding or ribbon roughly 48 inches long
3. Brightly coloured thread or cotton.
4. Fabric scissors or pinking shears if you have them.
To begin with, fold the plain fabric in half. This will help strengthen the water carrier and gives a neat finish to the top edge and will stop it from fraying.
Cut the patterned fabric (using pinking shears if you have them) so it comes to about the third of the size of the plain fabric and sew it so there is a 1.5 inch of plain fabric showing at the top. I machined stitched it which speeds the whole process up, but it would also be quick to sew by hand. Alternatively you could use bondaweb to adhere the two fabrics together.
I also did a simple running stitch about a cm from the top of the fabric. This isn't essential but if you use a bright coloured thread it does make the carrier look even prettier :)
With the right side of the fabric on the inside, fold it in half and stitch down the right hand side leaving an inch seam allowance. At this point you could just check that the sizing so far is right by using a standard empty water bottle - adjusting the seam allowance if needed.
In the same way that you would wrap a present, fold up the ends of your carrier, pin them together and sew! Strong thread is needed here - don't worry about it looking too neat as it won't be seen but its important that the ends are secure so you don't lose your drink!
Tie your three colours of binding or ribbon together and plait them - ending with another knot. Sew each end on to the insides of your carrier - again make sure you use strong thread and go back over your stitching several times as you don't want the strap to break.
Cut off any lose threads and ta da! Your drinks carrier is complete! Enjoy!